I just rebuilt the front fork 100% new bushings, new seals, new progressive, new Orings and brass washers. As soon as I hit the first bump I looked...
Last post
I suggest you purchase a Motion Pro fork seal driver and not use a pipe. I went thru so may seals and leaks until I brought the proper tools for the...
I can't shift up.Shifts into 1st gear smooth & normal,clutch works fine,takes off fine,but can't shift up.It just goes into neutral.Then the only way...
Last post
I found out that moving does not mean just coasting. (I was trying to bump-start down a hill that wasn't very steep. It's also good to check the kill...
I read through the tech write up and I believe I can handle this rebuild fairly easily, however I have a few questions. Does the progressive swap out...
Before I try to buy and throw a speedo gear on the front wheel is there anywhere else I should check on this bike? I'm new to the voyager series and...
Last post
I agree! I couldn't have done it without everyone here's collective knowledge. I am so glad I stumbled across this forum and all the willing to help...
I just traded my 94 Virago 1100 for a 96 Voyager 1200 XII and took it directly to my shop to have it given a go-over. At 94k miles I thought it would...
Last post
Personally I would go with OEM as I have found the standard of acceptable limits is higher with OEM.
And also, $100.00 is not a lot of money nowadays...
Hey guys, I have the wheels off since I got some new tires, and I was going to do a thorough cleaning of the rims before I put them back on. There's...
Last post
Have you thought about powder coating. Lots of colors to choose from, looks nicer, lasts way longer, easier to clean and in my experience cheap to...
When there is conversation about the clutch master cylinder vent hole, where is it located? Clutch master cylinder cap, diaphragm, internal housing,...
Last post
Thank you, turns out this was the problem with my clutch. It had set for some time and when I rode it, the clutch quit disengaging. It was low on...
I've committed the cardinal sin of not documenting parts, and after a year or two of working on this thing, I don't even recognize these pieces. But...
Last post
Mystery solved: they're the clips from around the headlight assembly. I was trying to see if it would separate for lubricating (it doesn't seem to,...
I recently changed and bled the clutch and brake fluid on my 94 Voyager. Now I have no neutral light, and the bike stalls when clutch lever is...
Last post
I found my issue (with neutral light not coming on and bike had to be started with clutch in, and would die when I released the clutch). I remembered...
Are there any tricks to make replacing the bearings easier? Do I need to basically remove the forks and then the triple tree? Can the lower be done...
Last post
Like the other responder, I've never replaced the steering head bearings. I have 455,000 miles on my '86. I have adjusted them, re-greased them every...
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
No unread posts No unread posts No unread posts [ Popular ] No unread posts [ Popular ] No unread posts [ Locked ] No unread posts [ Locked ]
Announce Announcement Sticky Sticky Moved topic Moved topic
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum