Moving Floorboards back

This is for general posts and questions concerning only the Kawasaki Vulcan Voyager 1700 V-Twin.

Moderators: the2knights, Highway Rider

Post Reply
User avatar
HMB Don
Past Board Member
Past Board Member
Posts: 756
Joined: Thu Apr 10, 2008 1:44 am
16
Current bike(s): 2012 Voyager 1700
Location: Wilmington, NC
Has liked: 0
Been liked: 81 times

Moving Floorboards back

Post by HMB Don »

I got the left floorboard moved back 3 1/2 inchs, it wasn't bad. But it sure makes riding the Voyager much better then before. I've logged over 1,000 miles with just the left moved back, tomorrow I be riding to NorCal Member Jerry Z's. garage to fab the right side floorboard, which will need to be cut and welded back togather.

One draw back is that the floorboard on the left drags much sooner, I might have to reposition that floorboard just a bit higher or slow down. Will have them finished and powder coated by Kanab. Trying to make me a hot rod special.

I now have a seating position like the 1200 Voyager, which fits me much better. I'm sure you'll like what I've done when you see me in Kanab, UT. If you like it vote for me during the bike show. Is that cheating asking for votes this far out?

Don Medina
2012 Voyager 1700
Don Medina
NorCal Voyagers Club


2012 Voyager 1700
User avatar
David (N. Alabama)
Elite Tourer
Elite Tourer
Posts: 816
Joined: Thu Feb 21, 2008 1:20 pm
16
Current bike(s): 2007 Kawasaki Mean Streak
2010 Kawasaki Vulcan Voyager 1700
2011 Kawasaki Versys
2012 Kawasaki KLX250S
2010 Moto Guzzi V7 Café Classic
1975 Kawasaki KT250 Trials
2014 Triumph Trophy SE
Location: Tennessee
Has liked: 0
Been liked: 0

Re: Moving Floorboards back

Post by David (N. Alabama) »

Looking foreward to seeing the bike at Kanab. Once in a while I want to slide my feet back during an all day ride and the heel shift does get in the way. Most of the time though I have my heels on the boards and my toes on the highway pegs. Sounds to me like you possibly created the Goldwing riding position on the Voyager.
2010 Voyager 1700
Image
User avatar
HMB Don
Past Board Member
Past Board Member
Posts: 756
Joined: Thu Apr 10, 2008 1:44 am
16
Current bike(s): 2012 Voyager 1700
Location: Wilmington, NC
Has liked: 0
Been liked: 81 times

Re: Moving Floorboards back

Post by HMB Don »

I finished the right floorboard yesterday, it was a 128 mile ride home. What a differance it made, feels much better for me with my short inseam. I can now use the whole floorboard to move my feet and I adjusted the rear brake pedal down. I had to reposition the left floorboard it was to low and I was dragging hard parts. I raised it 3/8 inch and it made a big difference, feels alot like the 1200 Voyager. Now all I need is a shaft drive assy. Takes a lot of pressure off the back side so I will now be able to ride all day with of back pain.

All it took was a wielder, hacksaw, grinder, drill and a whole day. Total parts $150.00 included were new right floorboard mounting bracket, new shift rod, 15" of 1/4" flat steel, some spray paint.

Don Medina
2012 Voyager 1700
Don Medina
NorCal Voyagers Club


2012 Voyager 1700
User avatar
debron
Past Board Member
Past Board Member
Posts: 1087
Joined: Mon Aug 23, 2010 5:54 pm
13
Current bike(s): 1995 Voyager XII
Location: Stayton, Oregon (Close to)
Has liked: 0
Been liked: 1 time

Re: Moving Floorboards back

Post by debron »

Photos......we want photos!!
Ron in Oregon
AVA Webmaster ("master" is optimistic!)
AVA Board Member
1995 Voyager XII
Image
User avatar
HMB Don
Past Board Member
Past Board Member
Posts: 756
Joined: Thu Apr 10, 2008 1:44 am
16
Current bike(s): 2012 Voyager 1700
Location: Wilmington, NC
Has liked: 0
Been liked: 81 times

Re: Moving Floorboards back

Post by HMB Don »

This is stock location of the right floorboard...(this is a test)
Image
Don Medina
NorCal Voyagers Club


2012 Voyager 1700
User avatar
debron
Past Board Member
Past Board Member
Posts: 1087
Joined: Mon Aug 23, 2010 5:54 pm
13
Current bike(s): 1995 Voyager XII
Location: Stayton, Oregon (Close to)
Has liked: 0
Been liked: 1 time

Re: Moving Floorboards back

Post by debron »

HMB Don wrote:This is stock location of the right floorboard...(this is a test)
Image
Don, I think you passed! :thmup:
Ron in Oregon
AVA Webmaster ("master" is optimistic!)
AVA Board Member
1995 Voyager XII
Image
User avatar
HMB Don
Past Board Member
Past Board Member
Posts: 756
Joined: Thu Apr 10, 2008 1:44 am
16
Current bike(s): 2012 Voyager 1700
Location: Wilmington, NC
Has liked: 0
Been liked: 81 times

Re: Moving Floorboards back

Post by HMB Don »

Here we are, the first picture is the stock location of the right floorboard. See how are the floorboard extends onto the lower faring
Image
Here is the finished floorboard, notice how far back from the fairing and the rear brake pedal the floorboard sits
Image
Left side again see how far back the floorboard sits from the lower fairing
Image


Don Medina
2012 Voyager 1700
Don Medina
NorCal Voyagers Club


2012 Voyager 1700
Post Reply

Return to “General - Voyager 1700 V-Twin”