Still can't get it to start. Cranks strong and sound like its trying to start. Getting some heat from the crankcase so I think at least a cylinder is...
Last post
You're holding the throttle WFO for the test, right? Worst case, you got some bad rings or bad valves or both. Best case: rings are a bit sticky...
I found a nice 88 1300 for a price I could not pass on. Needs a little work but runs super.I have been looking for an 87 or 88 since I lost one to a...
As new wires are either unobtanium or crazy expensive, what are my options for new spark plug wires?
Last post
I'd just measure the size of the wire (some are 9mm, some are 10mm ??) and buy a length of spark plug wire from your local auto supply. Pull of your...
Does anyone know what the toggle switch is below the CB display on the fairing? I don't see it mentioned in any books.
Thanks
Last post
Going from memory here - I think it's a switch to allow the CB to mute other audio when in use. So audio from the CB would (when active) either mute...
Looks like I need to replace the battery cables on my ZN1300. I see they aren't available anymore and wanted to know what you out there have found....
Last post
Put in another starter and it cranks great. Still won't start, but I have a feeling its the coils. 1 problem down, several to go. May be time to just...
I can barely get a air chuck on my rear tire valve because of limited clearance between the valve tip and the wheel hub. I can't believe it came from...
Last post
Just updating this.....
The adapter broke the first time I used it. I had a second one which I was able to use gingerly and get air in the tire....
On every 1300 Voyager I've ever seen (admittedly - that's not many) the aluminum (I think it's aluminum) brackets that hold the footpegs and the rear...
Last post
Sweet! The bike looks familiar (same colour as mine :-D )
Your bits look a bit more of a semi-gloss finish which is what I would have preferred.
One of the shock absorber on the rear of my 1300 Voyager is leaking oil. Are there repair kits available in the US (I guess only a gasket would need...
Last post
Most brands sealer/conditioner are going to be the same .
Best you can do is if it does say the viscosity (most will not)go with a lower one .I...
Does anyone know where to find a parts fiche for the optional bits on a Voyager? Specifically, I'm looking for CB handlebar switch control parts -...
Last post
Thanks for the tip Mr. J. The cutters I have actually thread the bolt in first so any thread distortion from cutting is smoothed out when the bolt is...
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
