Hello everyone! As of today, we have 90 registered! That's going to be a great turn out!
Just a reminder that rally registration closes on May 9 so that we can place our t-shirt order for the rally.
If you are coming, but have not sent in your registration, do it TODAY or TOMORROW!
After that, we will not accept any orders for t-shirts. We order a few extra of the most common sizes for the rally. You can only get what is available.
Have you all made your hotel reservations? If not, do it NOW! If our blocked rooms are full at Laquinta Inn, you'll have to find other lodging.
See you all soon!
Got a tech tip for Voyager 12's from your personal experiences, or one complete with pictures and instructions, here's where to post it. You can also ask about tips or procedures here.
Just purchased a 1986 Voyager XII. The wiring has been seriously tampered with. I downloaded the service manual from this site but the wiring diagram...
Last post
Thanks for the help. I now see the manual section.
Hi, Everyone;
Just got my '03 VXII back from the mechanic after a carb rebuild and some forkseal work, and I'm having a problem. When I am traveling...
Last post
For me what I found I believe is the main problem is a PO had put E3s on.
On Saturday, my wife on her Burgman 400, and me on my 1996 VXII was traveling from NY to Cape Cod, Mass. for weekend getaway. It was a sunny...
Last post
I converted all lights, except the instrument bulbs, to LED's several years ago. My Voltmeter reading increased by just over 1 Volt. I connected mine...
Gertrude's top box has been loose and rattling around for a while. I knew new plastic doohickeys were needed. Visiting Gene on Sunday, he suggested...
Last post
It's not actually directly bolted into place, all the plastic bushing are still there. All I did was take the metal collars out so the plastic could...
I removed my carburetors some time ago to have them rebuilt. I've installed the rebuilt carburetors along with the air box, but cannot remember nor...
Last post
Thanks. Looking at the top of the breather body I can see where it fits now. I don't know how it happened, but the tube opening is pointed upward, so...
Still trying to get my cruise control to work.
Question:
If I get a SET light on the switch box (on the faux tank), when I push the SET switch on the...
Last post
that is kind where I thought we might be going with this one. Can you give a quick location to look for the overdrive switch? I've cleaned the two...
Just picked up this nice bike a week or so back. 42K on it and I listed what was done to it in my Hello post. New Galfer Teflon/SS hoses were put on...
Last post
As far as I know, there is no power to the rear brake, no pump, nothing but a manually controlled hydraulic piston system, similar to the front...
ok so i have a clunking noise in drive line sounds like the drive shaft have rear wheel off and final drive off splines on final drive and end of...
Last post
Well that is one I will remember!
I have some new springs so I am going to record the free, uninstalled length and in future I am going to check any...
Yesterday I was installing a pump on a 93 I am rebuilding and I thought I should test the pump for operation before I put it in .
Now to back up a...
Last post
I own a '93. Our fuel pump died, 75 miles from our hotel, in Arkansas... They can, and do, fail. Just an FYI. :-( Our bike currently has 75k miles on...
What is the drain plug sticking straight forward from the front bottom of the engine?
I thought it was oil,...
Last post
Check out the tech tip section.
Go to the top of any page. In the green area on the left is AVA Home click it.
On the left click on Tech Center
Then...
Hi
I noticed in the dollar for dollar a K&N substitute. Quick question.....In the past I have always had to re jet the carbs with these filters....
Last post
Maybe it's just my suspicious nature, but I wonder, since it's a GM engine and the GM filter so handily outperformed the rest, despite the assurances...
I got an e-mail forwarded to me from Tim Partridge who bought a 1991 Voyager
last year. He started taking things apart and would like a little help....
Well now that wasn't bad at all. Fortunately the old shocks held air long enough for me to get her up on the center stand, otherwise I would have had...
Last post
Gene and I replaced the front springs last August:
20200815_144755.jpg
As for the rear shocks, I bottomed them out for the first time day before...
I am in search of a diagnosis for my clutch problem. :help:
While at a traffic stop recently, the bike wanted to nudge forward. I...
Last post
Speed Bleeders have a sealant coating, brownish-red color, which wears off, over time with opening/closing for bleeding purposes. They sell it , in a...
Sometime ago someone posted a color diagram of fuel filter and fuel pump lines. I have used the search feature and haven't been able to find the...
Last post
I don't need this now as I discovered the online manual had clearer photos of the fuel filter and fuel pump than my printed service manual has. This...
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
