Got a tech tip for Voyager 12's from your personal experiences, or one complete with pictures and instructions, here's where to post it. You can also ask about tips or procedures here.
I just got in a set of carbs from a '97 that I'll be putting on my '86. While initially messing around with them I notice this broken, threaded boss...
Last post
My confusion was in reading that the cruise control somehow was associated with the boss. Now I know that this is necessary for normal throttle cable...
I could really use some help on thos one. I finally got the Voyager back together and running ... sort of. I have been trying to sync the carbs for a...
Last post
Hello from NJ. well adjusting the PILOT FUEL SCREWS , will do nothing for balancing the vacuum readings. put the pilots BACK where they were. It is...
Hello guys,
I just got my 2001 out of storage and found that I have a gas leak where the gas line goes into the carbs. It is driving me crazy that I...
Last post
Marvelous dissertation on fuel rail O-rings Dave. I ended up shoveling out $4.41 ea. at the dealership because I needed to get it back together. I...
What I did when I had that problem, was remove the two screws as you did, then I could flip the roundish thingy upside down or on it's side and that...
Last post
Thanks to everyone for your suggestions! Now I'm going to tackle the extremely difficult cold start issue (with a new post).
It's 37 degrees on February 28th, I think I'll work on my bike!
Has anyone found a cost effective replacement for these?
sidebagcover.jpg...
Last post
Yeah, they do look good. They were greywalls for a while lol. Came clean pretty good with the pressure washer and a bit of elbow grease. Hopefully it...
As I was pulling the carbs I Planned on detaching the two clear hoses from the carbs as I wasnt sure where they ran to other than up behind the fuel...
Last post
We are glad you got her to run so much better without much work :perfect10: :thmup:
Keep us posted on your progress :clap:
Ok guys, what seems to be the preferred method to start this thing after it has been sitting for a few months? Mine will turn over all day but won't...
In my search for the non-existent fork o-rings, I was referred to a place just outside of Philadelphia called Sealing Specialties . Nick measured my...
If I understand the process correctly, it should go similar to this?
Soak the new plates
Drain oil
Remove case
Remove spring bolts and springs...
Last post
How is your progress coming?
I had my clutch and brake fluid changed in 2021. The tech changed out the levers and master cylinders due to corrosion....
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
