Got a tech tip for Voyager 1300's from your personal experiences, or one complete with pictures and instructions, here's where to post it. You can also ask about tips or procedures here.
Can someone with a manual tell me the correct clearances for my 86 ZN1300 Voyager please. Also wondering if anyone has located and successfully...
Last post
Shims are commonly available. I'd go to my local dealer and see what he wants for shims. If that's too expensive or not optimal, there's always eBay...
I was able to add a working cruise control to my 1300.
The one I picked was a universal mount for a 80something car found on ebay for under a hundred...
Last post
Yup . You are correct .
I notice now there is no throttle cable on it.
Sorry . I guess I should look a little closer next time .
I knew something did...
Evening folks. I recently replaced the push and pull throttle cables on my `88 1300, and it seems I've done something wrong. I now have to twist the...
Last post
Do you have a set of manuals for this bike? At the rear of the supplement manual is a 13 page section dealing solely with the cruise control system...
Hi folks. I have a question that has sort of been answered in other posts, but I want to take it in a different direction. I'm also new here, so hey...
Last post
They have adequate volume but they will never compete with the larger speakers that come on today's newer bikes.
I agree Krasmu, but I figure that...
I'm having an issue with my front wheel. The bounce does not appear until I get to about 30 mph. Above 30 the bounce disappears. I replaced the tire...
Last post
I agree with Me Again, bad oil or wrong viscosity or wrong type of shock oil. to much or to little shock oil.
My ZN 1300 does start excellent. Running good. Temperature constant and good. After she gets warm the idle will stay at what ever I adjust too. Lets...
Last post
My ZN 1300 does start excellent. Running good. Temperature constant and good. After she gets warm the idle will stay at what ever I adjust too. Lets...
Only problem with that is it's not the part that usually gives out.
That would be the nylon gear inside the engine ,you need to pull the head to get...
I'm trying to find out how hard is it to install an aftermarket radio on the 84 voyager.I will appreciate any help
Last post
Depending on why you need it fixed ,you may be better off going on fleabay and buy a new controller .just remember to change locks before you snap it...
Well, here's the progress on the Hondasaki drive, as Tony (Lucasind) calls it!
A brief update on the history of this project here. Tony didn't like...
Last post
.....Wishful thinking perhaps, ...but ALL this will NOT happen in the next 90 days !
Time to head to the rally will be here before ya know it ! Bruce...
I've been reading about the dreaded CCT. At what mileage do you need to worry about changing it out? How do you know it needs replacing? Does it make...
Last post
....You are right trike....If a guy had a machine shop, and the skills,this manual tensioner would be a fun little project ! I remember replacing...
Bought some Fram CH6013 oil filters for my ZN1300. The large o-ring for the cover that came with the filter is way to big. I checked all six filters...
Last post
Thanks, Bill. That's what I was down to as options. On another 1300 site a guy said he did some cross-referencing between brands and the the Fram...
Stated tire sizes for the ZN1300 are 110/90 V 18 for the front, and 130/90 V 17 for the rear. The 90 aspect ratio is the problem when sourcing the...
Last post
I found this page that tells almost the whole tire story. It sure answered all of my questions, as well as letting me find the exact sizes of Elite 3...
Hello everyone,
I am a former AVA member (back when Bob and Glen were active), but haven't been riding for 8 years now. I'm in the process of getting...
Last post
Hi Roland.
Guido actually signed up on this forum in Feb ,said hi and signed off .
Hasn't been back but did leave an email addy in his profile.
I have had my 84 1300 for two years now and love it, but now I have a problem that I can't figure out. I started having problem with it losing power...
Last post
I just joined this forum today, and just picked up my second Voyager 1300 this week. It was missing parts and had broken ones, and I have had great...
ok. I have read everything regarding these things running hot/ overheating, but cannot find an easier way to get air out of the line. per the manual,...
Last post
my wife is convinced the bike is just 'finicky' like its owner...???
I am thinking of getting a 84 Voyager with a 1500? Though I think its really a 1300. i havnt seen it yet gotta set a time BUT here is the catch...the...
Last post
Haven't met him yet. But he said he is tall when I asked him about the height of the bikes seat section... why?
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
