Hello everyone! As of today, we have 90 registered! That's going to be a great turn out!
Just a reminder that rally registration closes on May 9 so that we can place our t-shirt order for the rally.
If you are coming, but have not sent in your registration, do it TODAY or TOMORROW!
After that, we will not accept any orders for t-shirts. We order a few extra of the most common sizes for the rally. You can only get what is available.
Have you all made your hotel reservations? If not, do it NOW! If our blocked rooms are full at Laquinta Inn, you'll have to find other lodging.
See you all soon!
Just a reminder that rally registration closes on May 9 so that we can place our t-shirt order for the rally.
If you are coming, but have not sent in your registration, do it TODAY or TOMORROW!
After that, we will not accept any orders for t-shirts. We order a few extra of the most common sizes for the rally. You can only get what is available.
Have you all made your hotel reservations? If not, do it NOW! If our blocked rooms are full at Laquinta Inn, you'll have to find other lodging.
See you all soon!
No start after oil sump replacement
Moderators: the2knights, Highway Rider
-
On-rock1
- Newbie
- Posts: 5
- Joined: Thu Jul 27, 2017 2:03 am
- 7
- Current bike(s): R1200GS BMW
Xii Voyager
FXD Dyna Super Glide - Has liked: 0
- Been liked: 0
No start after oil sump replacement
I have a 2000 xii that I high centered on the oil filter bolt and we'll you know what happened. Long story short everything was replaced and now back together but it appears that because all the oil was removed the pressure switch needs to be reset or something else that is causing the starter not to engage. The only wire I touched was the wire to what looks like a pressure switch on the olive pan. Help and thanks for any information.
-
Barry
- Grand Tourer
- Posts: 398
- Joined: Thu Feb 21, 2008 2:00 pm
- 17
- Current bike(s): 87 Voyager 12
- Has liked: 100 times
- Been liked: 69 times
Re: No start after oil sump replacement
Did you check the side stand safety switch and the wiring to it?
Barry
87 Voyager XII
87 Voyager XII
-
cushman eagle
- King of the Road
- Posts: 2035
- Joined: Sat Jan 22, 2011 10:08 pm
- 14
- Current bike(s): '99 Kawasaki Voyager 1200
1958 Cushman Eagle restoration has been finished,and have put 4050 miles on her! - Location: Orrville,Ohio
- Has liked: 893 times
- Been liked: 315 times
Re: No start after oil sump replacement
The oil pressure switch would not affect the starter circuit.Did you check the kill switch by your right thumb? I have bumped that already,and could not start until I turned it back to the run position.As Barry said check your side stand switch.If neither is the cause,You can download a service manual online,which can help find the problem. 
Keep us posted on what you find.
Keep us posted on what you find.
'99 Voyager VXII,'58 Cushman Eagle