Hello everyone! As of today, we have 90 registered! That's going to be a great turn out!
Just a reminder that rally registration closes on May 9 so that we can place our t-shirt order for the rally.
If you are coming, but have not sent in your registration, do it TODAY or TOMORROW!
After that, we will not accept any orders for t-shirts. We order a few extra of the most common sizes for the rally. You can only get what is available.
Have you all made your hotel reservations? If not, do it NOW! If our blocked rooms are full at Laquinta Inn, you'll have to find other lodging.
See you all soon!
Just a reminder that rally registration closes on May 9 so that we can place our t-shirt order for the rally.
If you are coming, but have not sent in your registration, do it TODAY or TOMORROW!
After that, we will not accept any orders for t-shirts. We order a few extra of the most common sizes for the rally. You can only get what is available.
Have you all made your hotel reservations? If not, do it NOW! If our blocked rooms are full at Laquinta Inn, you'll have to find other lodging.
See you all soon!
Conflicting as to setting the carb floats
Moderators: the2knights, Highway Rider
-
Avidrider62
- Tourer
- Posts: 226
- Joined: Sat Dec 13, 2014 9:12 pm
- 10
- Current bike(s): Bikeless
- Location: Valdosta, GA
- Has liked: 1 time
- Been liked: 3 times
Conflicting as to setting the carb floats
Bill Overton and Carl Leo mention two different ways. Put the carbs, flat (floats up) and carbs at an angle as to where the needle just touches the seat. Two different results. 17mm is the norm , Bill says about 18mm , to avoid rich.
2003 with 87 colors
-
chevyman1
- Board Member
- Posts: 732
- Joined: Sat Jun 06, 2009 5:59 pm
- 15
- Current bike(s): 1990 Kawasaki Voyager XII
1991 Kawasaki Voyager XII
1993 Kawasaki Voyager XII
1972 Yamaha LS2 100cc twin 2 stroke - Location: Myerstown, Pa.
- Has liked: 0
- Been liked: 16 times
Re: Conflicting as to setting the carb floats
When I do the carbs I set them to 18MM. holding the carb sideways so the float is just touching the needle lightly
I be leave that's what Carl recommends.
I be leave that's what Carl recommends.
President - Mid-Atlantic Voyagers
1990 Voyager XII
1991 Voyager XII (Team Green)
1972 Yamaha LS2 (100cc Twin 2stroke)
Voyagers Voice editor SEND ME STORIES AND PICTURES PLEASE
to. (kew427@comcast.net)
1990 Voyager XII
1991 Voyager XII (Team Green)
1972 Yamaha LS2 (100cc Twin 2stroke)
Voyagers Voice editor SEND ME STORIES AND PICTURES PLEASE
to. (kew427@comcast.net)