Hello everyone! As of today, we have 90 registered! That's going to be a great turn out!
Just a reminder that rally registration closes on May 9 so that we can place our t-shirt order for the rally.
If you are coming, but have not sent in your registration, do it TODAY or TOMORROW!
After that, we will not accept any orders for t-shirts. We order a few extra of the most common sizes for the rally. You can only get what is available.
Have you all made your hotel reservations? If not, do it NOW! If our blocked rooms are full at Laquinta Inn, you'll have to find other lodging.
See you all soon!
Just a reminder that rally registration closes on May 9 so that we can place our t-shirt order for the rally.
If you are coming, but have not sent in your registration, do it TODAY or TOMORROW!
After that, we will not accept any orders for t-shirts. We order a few extra of the most common sizes for the rally. You can only get what is available.
Have you all made your hotel reservations? If not, do it NOW! If our blocked rooms are full at Laquinta Inn, you'll have to find other lodging.
See you all soon!
Rear Shock replacement
Moderators: the2knights, Highway Rider
-
iowawill
- Newbie
- Posts: 8
- Joined: Sun Jun 06, 2010 5:02 pm
- 14
- Current bike(s): 1983 vf750c Magna
2002 Voyager12 - Location: Perry, Iowa
- Has liked: 0
- Been liked: 0
Rear Shock replacement
I just installed new progressive 412s on my '02 and was wondering if anyone could tell me torquing spec on the mounting bolts. Also, progressive included flat washers in the installation hardware but I just used the original hardware..was there some reason to use these flat washers? Also, I see in some recent posts that some have taken off the trunk to do this install, but I was able to slide the frame back far enough to install without removing the trunk. Seemed to go back together ok?
-
triton28
- King of the Road
- Posts: 1028
- Joined: Fri Aug 23, 2013 1:32 am
- 11
- Current bike(s): 1987 ZG-1200 B1
1987 ZG-1200 B1
1990 ZG-1200 B4 - Location: Nova Scotia Canada
- Has liked: 117 times
- Been liked: 290 times
Re: Rear Shock replacement
22 foot pounds- upper and lower.
The 2 upper mounts use a flat and a lock washer, and the lower LH mount uses
a flat only.
Dave
The 2 upper mounts use a flat and a lock washer, and the lower LH mount uses
a flat only.
Dave