Hi everyone, I am looking for the exhaust gasket between the two mufflers, partzilla says they are unavailable. Does anybody know where else I might find them. I was going to try the dealership as a last resort.
Thanks
Hello everyone! As of today, we have 90 registered! That's going to be a great turn out!
Just a reminder that rally registration closes on May 9 so that we can place our t-shirt order for the rally.
If you are coming, but have not sent in your registration, do it TODAY or TOMORROW!
After that, we will not accept any orders for t-shirts. We order a few extra of the most common sizes for the rally. You can only get what is available.
Have you all made your hotel reservations? If not, do it NOW! If our blocked rooms are full at Laquinta Inn, you'll have to find other lodging.
See you all soon!
Just a reminder that rally registration closes on May 9 so that we can place our t-shirt order for the rally.
If you are coming, but have not sent in your registration, do it TODAY or TOMORROW!
After that, we will not accept any orders for t-shirts. We order a few extra of the most common sizes for the rally. You can only get what is available.
Have you all made your hotel reservations? If not, do it NOW! If our blocked rooms are full at Laquinta Inn, you'll have to find other lodging.
See you all soon!
Exhaust gaskets
Moderators: the2knights, Highway Rider
-
cushman eagle
- King of the Road
- Posts: 2036
- Joined: Sat Jan 22, 2011 10:08 pm
- 14
- Current bike(s): '99 Kawasaki Voyager 1200
1958 Cushman Eagle restoration has been finished,and have put 4050 miles on her! - Location: Orrville,Ohio
- Has liked: 893 times
- Been liked: 315 times
Re: Exhaust gaskets
Hi,Hillbilly,I would think you could get a piece of gasket material from your local NAPA dealer and roll it in to a sleeve and push it in 
We use gasket material in our repair shop that is black,and almost looks like compressed leather,which I think would do the job.
We use gasket material in our repair shop that is black,and almost looks like compressed leather,which I think would do the job.
'99 Voyager VXII,'58 Cushman Eagle
-
mrbmoran2
- Streetster
- Posts: 24
- Joined: Tue May 12, 2020 1:08 am
- 5
- Current bike(s): 2003 Voyager
2006 Concours
2000 Honda Shadow Ace Tourer
1999 Honda Shadow Ace Tourer - Has liked: 7 times
- Been liked: 4 times
Re: Exhaust gaskets
There was one on Amazon, but now it shows not available.
Be careful if you bought it, they are fragile.
I recently put my bike back to factory exhaust because PO had cut the connection in the middle and welded and closed each side off.
Be careful if you bought it, they are fragile.
I recently put my bike back to factory exhaust because PO had cut the connection in the middle and welded and closed each side off.