Hello everyone! As of today, we have 90 registered! That's going to be a great turn out!
Just a reminder that rally registration closes on May 9 so that we can place our t-shirt order for the rally.
If you are coming, but have not sent in your registration, do it TODAY or TOMORROW!
After that, we will not accept any orders for t-shirts. We order a few extra of the most common sizes for the rally. You can only get what is available.
Have you all made your hotel reservations? If not, do it NOW! If our blocked rooms are full at Laquinta Inn, you'll have to find other lodging.
See you all soon!
Just a reminder that rally registration closes on May 9 so that we can place our t-shirt order for the rally.
If you are coming, but have not sent in your registration, do it TODAY or TOMORROW!
After that, we will not accept any orders for t-shirts. We order a few extra of the most common sizes for the rally. You can only get what is available.
Have you all made your hotel reservations? If not, do it NOW! If our blocked rooms are full at Laquinta Inn, you'll have to find other lodging.
See you all soon!
Front Bevel problem
Moderators: the2knights, Highway Rider
-
Djfon33
- Newbie
- Posts: 2
- Joined: Sun Aug 14, 2016 9:20 am
- 8
- Current bike(s): Kawasaki ZG 1200
- Has liked: 0
- Been liked: 0
Front Bevel problem
OK ANYONE... HELP PLEASE.. I HAVE A ZG1200 1989 VOYAGER , AND IT HAD A SMALL LEAK COMING FROM THE FRONT BEVEL. WELL I DECIDED TO TAKE OFF THE FRONT BEVEL CASE TO REPLACE THE GASKET. SO I REMOVED REAR TIRE, DRIVE SHAFT, EXAUST, Waterpump...etc.. anyway i got it off and i didnt see anything fall out but a little dime size washer, and a dime size rubber piece about a 1/4 in thick with hole in the middle. So i put a liquid gasket around lip and replaced the cover ..as for the washer i put on the bar to the right that changes gearz and i put the rubber piece on the lefxqdt where a silver rod sticks out of the tranny.. After i got it all back together i started it fine. But now the gear for the clutch peddle wont engage it moves up and down ...but does not change gears.. i then looked around bike and found a dime size circular steel ballbearing... but was just wondering does maybe it go in bevel.. or not.. or any idea why its now not working... im stuck